Custom tagging instructions

Updated Nov 8, 2026 · 2 min read

Tell AI tagging in your own words what to tag and which tags to prefer or avoid. The same instructions go to every provider.

From Meshory 1.13.0, you can add your own guidance to the prompt Meshory sends when it tags your models. Use it for what matters in your library: tag Marvel and DC models with the franchise name, or prefer character names over generic tags like model or 3D print.

Write your instructions

  1. 1Open Settings → AI tagging. Edit prompt, in the library's AI menu, takes you there too.
  2. 2Under Descriptions and tags, write your guidance in Custom tagging instructions, in plain words and up to 4,000 characters.
  3. 3Click Save prompt. To go back to the built-in prompt, clear the field and save again.

What they change

Instructions guide the model; they don't filter its output, so a model can still miss or misread them. Tags it's confident about are added without review, so try new instructions on one folder and check the tags before you run the whole library.

AI settings, instructions included, are locked while an AI run is active or paused: discard the run to change them. Your instructions belong to the library, so a library backup carries them and restoring it brings them back.

They go to the provider you picked inside every tagging request, so leave out anything you wouldn't send to that provider. What data is sent lists everything else that goes with them.

Did this page help?

Still stuck? Ask in the Discord